PRO1 · Sensor
PRO1 R751WO PROsync Wireless Remote Sensor
Indoor wireless temperature and occupancy remote for the T755WHO PROsync system, with display and local controls.
Will this work with my system?
Match your equipment to these requirements before ordering.
Works with
- T755WHO PROsync system, paired through its equipment module.
System requirements
- Required components: T755WHO PROsync wireless system
- Power: 2 AA alkaline batteries or 18–30 VAC, NEC Class II, 50/60 Hz
- Sensor signal: PROsync proprietary wireless
Required products
Limitations & exclusions
- Does not control heating or cooling equipment directly.
Check before you buy
- Match the full R751WO model number and hardware revision to the manufacturer's equipment manual and accessory list.
- Confirm that the exact host-controller model supports this sensor signal or wireless protocol, then check placement and connection limits.
Manufacturer documentation (2)
Use these documents to compare your exact model and configuration.
Overview
Part of the PRO1 PROsync Wireless system. See the system overview for component roles and selection requirements.
The PRO1 R751WO is an indoor wireless remote for the T755WHO PROsync system. It combines a temperature display, occupancy sensing and local controls, allowing the system to use remote room temperatures according to its configured schedule or occupancy mode.
The R751WO requires a T755WHO PROsync system and pairs to its equipment module. It is powered by two AA alkaline batteries or a suitable 24-volt supply. It is a system remote, with heating and cooling equipment control handled through PROsync.
Access can be left unrestricted, limited to temperature adjustments, or fully locked. Depending on the system configuration, interaction at a remote can place that room in control for a temporary four-hour override.
Install in a location representative of the room temperature, away from drafts, sunlight and heat sources. Use the installation and operation manuals for pairing, occupancy behavior and access settings.
Product details
- Manufacturer
- Pro1 iAQ
- SKU
- 107351
- Model / MPN
- R751WO
- Condition
- New
- Lifecycle
- Current
Specifications
- Required accessories
- T755WHO PROsync wireless system
- Power sources
- 2 AA alkaline batteries or 18–30 VAC, NEC Class II, 50/60 Hz
- Setpoint range
- 44 to 90 °F (7 to 32 °C)
- Operating temperature
- 32 to 105 °F (0 to 41 °C)
- Operating humidity
- 90% RH maximum, non-condensing
- Keypad lockout
- Off, partial or full
- Measurement channels
- Temperature display range: 41 to 95 °F (5 to 35 °C)
- Measured variables
- Temperature and occupancy
- Sensor output types
- PROsync proprietary wireless